Unit 801, Unit 2, Building 10, No. 280, Tailiu Road, 

Shibei District, Qingdao, Shandong Province, China




@ Power by Chinatoupees Own by Shunfa Hair 2022



Contact us

Mobile Phone: +86-135 8934 1657 (Whatsapp)

Email :

Tel :  +86-532-58828295        




How to Do Wig/Toupee Cap template Measurements


Factory recommend you browse "How to measure" page to ensure that every measurement is as accurate as possible before all order. This is very important to help both of us avoid measurement misunderstandings and thus  going back and forth over this issue quickly.

it is a complete guide to taking full wig measurements as below . there are seven step measurements in total correctly.Firstly, we can manufacture a wig cap that best fits your customer's head.


1.  Full-head Circumference

This measurement is from the perimeter around your head. Starting at the centre of the front hairline, rolling tape flat against head, going above ear towards the back of head, put tape at the nape of your neck and all around to the opposite side of your head, just above the opposite ear and trun back to the center of the front hairline.


2. Front Hairline to Back

Put the tape on the centre of the front hairline and measure across the middle top of your head to the nape of your neck directly. Please determine where the nape of your neck is, tilt your head back and look up. Part of your neck bends and the part you may have developed a skin fold is where your nape is. We want the bottom of the wig to sit right above this area so that when you do tilt your head back that far, your wig will not shift on your head. If this method can not work, the base will be longer than that.The occipital bone is the right position of this area. and ensure to make the measurement with your neck bent down , after this you are looking at your shoes.


3. Ear to Ear over Forehead

Put the tape at your temple, just in front of right ear. Start from your hairline at the base of the sideburn and surround the hairline along the forehead to the same point in front of left ear.


4. Temple to Temple

Put the tape on the bottom edge of the sideburn in front of your ear and go directly across the top of the head to the bottom edge of the opposite side burn. this is the measurement of your temple to temple length across the center of the head.

5. Ear to Ear over Top of Head

Put the tape from the hairline edge at the top of right ear and go across the top of your head to the hairline edge at the center of left ear directly.


6. Temple to Temple over Back of Head

Pur the tape against your head at your right temple. Go around the head above your occipital bone to your left temple.

At least , Writing all the final measurement on Factory Order Form.

If in need Order form , you can ask via Whatsapp: +86 13589341657 and Email